Torque Solution Rear Brake Caliper Adapter | Subaru Multiple Fitments (TS-SU-317)

Apparently this problem is common. They didn't fit without enlarging the holes on the brake backing plate and I had to run a drill bit through the caliper mounting holes on these because the bolts didn't fit well. I should have saved the money and got the cheaper ones since I would have had to do the same thing anyway. These went on a 2004 WRX to adapt the 2 pot rear calipers. I did make it work though.

These helped me upgrade my brakes on my 03 forester to the 2 pots subaru brakes in the back

One of the two brackets fit perfectly with no issues, while the other had a bit of an alignment defect in that the threaded holes were slightly off. This was not a big problem for me as my shop does fabrication and custom work on a daily basis, however the average Do-It-Yourselfer is likely not privy to the machining equipment we have and could run into installation trouble very quickly. I do, however still recommend them due to the cost savings, just be sure to check the fitment before you proceed. There is also no doubt in my mind that the good people at MA Performance and Torque Solutions will honor any type of warranted defect with customer satisfaction in mind, I was simply pressed for time and had to modify the brackets rather than exchanging them. - James Shelton, Rock Batter Garage

These brackets fit perfectly and are the best deal if you are looking to bolt on the FHI 2 Pot Caliper to your Subaru. It even comes with new hardware.