CAN Adaptor Loom
DTM-4 to 6-pin Circular Connector by Haltech
Used to connect supported Haltech CAN
devices to the 6 Pin circular connector CAN
port found on the Link Wire-in ECU's
This harness is designed to allow for quick
installation of your Haltech CAN based
accessory to your Link ECU equipped vehicle.
Please refer to your Link ECU wiring diagram
to find information which is specific to your
ECU model.
Features
Benefits
- Suits Dual Connector Link ECU’s
- Suits Dual-Connector Link ECUs Wiring of input power required
- Suits Haltech iC-7 Dash, WB1, WB2 and Link Wire-in ECUs (Storm, Extreme, Fury, Thunder, Force GDI)
Please Note: Please take care when wiring the adaptor loom as
incorrect wiring will damage the dash and/or ECU!
