GrimmSpeed Cold Air Intake | Multiple Subaru Fitments (060051)
GrimmSpeedFor years you've been asking for intakes, and for years they've silently worked to create a solution that sets itself apart from the rest. They examined and tested current offerings, and identified their shortcomings. They formed theories, and over months of testing designs we proved them. Combined with their advanced research and development program, they fully utilized our engineering resources to design and manufacture what we believe is the most comprehensive intake solution available for the 2008-2014 Subaru WRX and STI and the 2009-2013 Forester XT.
Benefits
- Hybrid Cold Air/Short Ram Design - Combining the advantages and eliminating the negatives of both traditional intake designs
- Air straightener - Dimensionally mimics the factory configuration for accurate MAF sensor readings
- MAF sensor location - Inside heat shield, isolated from engine bay heat
- Custom reusable high flow air filter - Integrated velocity stack entrance smooths incoming air
- Made in the USA - Right here in Minnesota, in fact
- 30min Installation - Extremely simple with our written and video guides
Applications
- 2008-2014 Subaru WRX
- 2008-2014 Subaru STI
- 2009-2013 Subaru Forester XT
What's in the Box?
- 1x Intake Tube
- 1x High-flow Oiled Filter
- 1x Hump Hose Connector
- 1x Heat Shield Assembly
- 3x Hose Clamps
- 2x MAF Flange Screws
- 3x Precut Rubber Sealing Strip
- 1x MAF Wire Grommet
Warranty
Warranty Information
Customer Reviews
Perfect fitment and Grimmspeed products are always quality
clean and stock looking intake, good build quality
Only reason im giving 4 stars is because of the intake temps. With stock intake on sti intake temps were about 7 degrees higher than regular temp. This intake gets rid of the stock air duct that takes in air from front of car resulting in average of 12 degrees hoter intake temps when cruising and in traffic I have seen it 140 degrees. I think part of the issue is where it pulls air from is behind radiator so ots taking in air thats passing through the radiator which is pulling heat from radiator. Personally probably going to sell this intake and buy the cobb cause it uses oem.
Simple, yet good and straightforward design. Install was easy and took about 30 mins. Works great!! I’ve had a few different designs on different vehicles, I definitely buy this one again.
amazing quality and works great
