MAPerformance Rev3 Modified Intake Manifold (Mitsubishi Evolution 8 / 9)

It's finally here! The MAPerformance ported Evo intake manifold!

This intake is unlike most anything on the market especially for the price. We are able to port the runners much further than most our competitors and fully port the plenum. But why stop there? This manifold is then cut, reshaped, and ported EVERYWHERE!! This will provide your stock manifold more airflow across the board, especially up top. Get the performance of a great intake manifold for a more affordable price.

This manifold was benchflowed before and after to ensure a quality, and more balanced flow between runners than the stock version provides. We were able to perfectly flow match runners 1 & 2 and reduce the overall flow imbalance between the best runner and worst (1 & 4 respectively) by more than 34%. This will mean the stresses will be more evenly distributed over your motor.

Our first test car was a stock turbo'd '06 Evo on an aggressive 93 pump tune. Initial testing shows an impressive +47tq and +35hp at 3800rpm and still had gains up until 6500rpm where the curve matched the stock manifold from there out due to fuel limitations. Expect more results from bigger turbos, and more revs as this manifold will help you really breathe above 7500rpm. More testing will be shown once it becomes available.

Optionally there is an advanced ceramic coating option that helps control heat soak in your manifold. The outside is coated in a thermal barrier (available in black only) that not only looks great, but actually helps pull heat out of the manifold. Not only that, but there is a thermal blocking coating that is on the flange that when combined with one of our spacers, will allow you to hold on to your manifold even after hard use at the track. A must for anyone wanting cooler intake temps and more consistent times.

Core Options

We offer three different options in regards to our intake manifold core service, please select the one that fits your specific situation and time line.

• Have Core, Will Wait: Select this option if you have a core intake manifold to send to us and you would like us to perform the services to your intake manifold after it has been received.
• Have Core, No Waiting Please: Select this option if you have a core to send in to us, but would like to keep downtime to a minimum. We will complete the services on a core intake manifold and refund the core charge as soon as we receive your intake manifold! Please note that your core exchange must be suitable for use as a core, feel free to contact us for more information!
• No Core: Select this option if you do not have an intake manifold to send in as a core. We will track down and purchase a good core to use for your intake manifold service. This charge is non-refundable.