ETS Intercooler Upgrade Kit | 2003-2006 Mitsubishi Lancer Evolution 8/9 (EVO-89-IC-Kit)
This item is built to order
and typically ships in 5-7 Days!
Mitsubishi Evo 8/9 Intercooler Upgrade Kit by ETS
The ETS Lancer EVO Intercooler is the best on the market, bar none. It features bolt on installation, eliminates the two up-pipes to the intercooler and fills the whole grill with core for a killer look and maximum efficiency. This unit also retains the factory crash bar and splash pans (3" and 3.5"). The kit includes the intercooler, mounting hardware, silicone couplers, and SS T-Bolt Clamps. Check out the features below:
The ETS EVO Piping kit is designed to eliminate many of the unnecessary bends in the stock piping. Our piping starts off by immediately expanding into 2.5” diameter right off of the turbo elbow. This replaces the tiny 1 3/4” factory pipe and instantly frees up 15hp and greatly improves spool up. From here it follows the core support and wraps around to mate up to the intercooler. Once the air passes through the intercooler, the piping takes a short direct path around the core support, over the transmission and straight up to the throttle body. This unique routing is over two feet shorter than the stock routing which results in greatly improved spool up and transient response. With an 11% increase in cross sectional area, flow is increased as well.
Also available for those with a Front Power Brace from Cusco. We make a bolt on intercooler that fits within the brace.
- Pressure Checked at 35psi
- Bolt on design retains crash beam (3" and 3.5")
- Fills entire grill with core
- Eliminates excessive piping
- Full Mandrel Bent 2.5" Piping
- Stainless Steel T-Bolt Clamps
- 3-Ply Reinforced Silicone Couplers
- Short Route: Two feet shorter than stock
- Lower piping flows over 20% more than stock
- Upper Piping flows over 12% more than stock
- Recirculation kit is only needed for Short Route UICP
- 2003 - 2004 Mitsubishi Lancer Evolution 8
- 2005 - 2006 Mitsubishi Lancer Evolution 9
Stock Route Piping Does Not Clear Air Box.
3" and 3.5" Requires Minor Trimming Only
4.0" Requires Trimming of Crash Beam
- 24x11.5x3.0" Core: 1058cfm-700hp at 79% efficiency
- 24x11.5x3.5" Core: 1127cfm-750hp at 80% efficiency
- 24x11.5x4.0" Core: 1219cfm-820hp at 81% efficiency
What's In The Box?
- 1 - Front Mount Intercooler
- 1 - Set of Intercooler Piping
- Silicone Couplers and Clamps
- Mounting Hardware
- Instructions/Manuals (if applicable)
- Warranty Information
ETS Lifetime Limited Warranty
The ETS intercooler and piping was a direct fit for my Evo 9 MR. Gives a super clean and mean look. Would definitely recommend to buy.